That's gonna make it wanna come down a little bit. Just take your small pocket screwdriver or even a pick, press right on that little white tab right there. To make this easier, I'll just put it in park and remove the key. And then if I move this out of your way, we'll see another one right there. Now, if you were to come right inside this area, you're gonna see a push tab right there. This is gonna give us a little bit of slack, we need that slack. Push on this tab, and then you should be able to pull this out. If you were to follow these wires up, you're gonna feel this little black connector right here. ![]() Now that we have everything out of the way, you have a nice clear view of where our part is. I'll get this one off and I'll show you this. You can see that there's the little hooky-dos here. So you just kind of need to go back a little bit before you lift up. You're gonna notice that there's a lip, it comes underneath this area of the steering wheel. And then I should be able to look this up a little bit and separate the two. You can also use a plastic trim tool if you feel like it's much easier for you, it might be safer as well. Use a small pocket screwdriver and be careful not to do this, it looks like somebody kinda already made a mess right there and I really don't want to do that as well. So, we're not gonna start there, that's we're gonna end, up long here's where we're actually going to start. In the back, there's gonna be a couple of little hooks. This is two pieces and it separates right down along this area. Next, we're gonna take off the steering column clamshell here. But before you do that, go ahead and bring this down so it's an almost straight position. Next, if you wanted to grab on to this, you'll be able to pull it right out. Our vehicle does not have any screws for some reason so I can't show you how to remove them but I'm sure you can figure it out. If you were to look right under here, you're gonna see some holes, there should be some screws located in there. Now, let's grab on to this, tilt our steering wheel. ![]() At this point, I'm gonna carefully grab on to this. Now that we have those bolts out, we're gonna take our key, put the key in the on position, and then with our foot on the brake, we'll put our gear shift all the way down. Right underneath the dash, you're gonna find two bolts, we're gonna remove those so we can get this panel off of here. Now, coming in from the driver side, we're gonna remove this little panel right here. One of the first things we need to do to start this job is to remove our negative battery terminal from the battery.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |